Press Operator

**Job Description** **Essential Duties Include:** * Read and understand “Change Spec. Card Procedure” * Read and understand “Non-Conforming Product Procedure” * Get magnets from magnet board that contains the work order information for production * Locate pallet or cart with the WOR folder containing the corresponding material, work order numbers and instructions * Determine and obtain the correct tool for the job identified on the Spec. Card from the tooling rack * Remove tooling from box, attach bearer blocks and slide into tooling station * Set the machine for the appropriate job * Retain Supplier raw material tag with lot # and run # information along with “Approved for Use” tags on separate sheet of paper (if only using partial material and retuning excess material do not retain tag, just record part #, lot # and run # on sheet) * Complete “Sign-off Check List” (if operator has less than 1-year experience, needs sign-off from experienced operator with over 1 year experience) * Print out (core tags or box tags) along with 1st piece and last piece labels with correct information, * Make sure the right material is used where needed, to the proper side of the liner and in the right orientation * Place material in machine.  Feed it through the fife guide and adjust it for center run. * Place adhesive in machine and line-up with materials so that they are even with each other * Start machine, adjust tension and alignment as needed * Pass the material through to the die cutting station * Remove any waste or air-injection from the tool * Adjust nip-roller speed for proper speed and dimensions of part * Verify part to print and or mylar and record dimensions * Retain first approved piece and place label on back side * Complete In-Process check sheet during the run. * Complete End-of-Run sign off confirming the required parts were produced. * Retain last approved piece and label back side * Maintain a clean and safe work area, cleaning floor, machine, work area at end of each job and at end of shift * Cut cores for particular jobs when needed.  Obtain boxes and materials necessary for job * Operate production equipment to produce good, quality product in an efficient/quality-oriented manner. * Makes suggestions for ways to improve production process * Works with sales and estimating to test/run samples for new product introduction * Makes sure product being produced matches the spec card and the degree of quality needed (tolerances etc..) * Updates spec card for future runs when process is changed * Observe machine operation to detect workpiece defects or machine malfunctions; adjust machines as necessary. * Change worn machine accessories such as cutting tools and brushes, using hand tools. * Perform minor machine maintenance, such as oiling or cleaning machines, changing filters or adding lubricant to the Rotary press when necessary. * Notify supervisors when major service is required. * Other duties as assigned. **Education:** High school diploma or equivalent **All Job Posting Locations** Grand Rapids **Remote Type** On-Site **EEO Statement** Boyd Corp is an equal opportunity employer. We celebrate diversity and are committed to creating an inclusive environment for all employees.